|
|
|||||||
| Register | Options | Profile | Last 1 | 3 | 7 Days | Search | Today's Posts | Mark Forums Read |
 |
|
|
Thread Tools |
|
#31
Sat 14 November 2009, 08:10
|
|||
|
|||
|
We have run direct-drive Z-axis for many years and have not seen a problem that it is too weak. If the router is switched on and the cutter is sharp right up to the middle/center of the cutter then the cutter dives right into hard wood.
|
|
| Register | Options | Profile | Last 1 | 3 | 7 Days | Search | Today's Posts | Mark Forums Read |
| Thread Tools | |
|
|
