Builder's Log Update
 

Greetings Vanja,

Congratulations on your new MechMate and on earning Serial #84.:)

Here is the Updated Builder's Log.

Please review your entry and let me know any changes you want to make.

Thanks all !!!!
Sorry for the worst built time I've done.

Center finding works like Danilo said. I have changed feed rate ( 100 insteed of 4):)

Congratulations Vanja! :)

Updated Builder's Log
 

Vanja,

The Update to the Builder's Log that you requested is complete, here.

Thank you for providing the update. I made the change at the airport while on vacation and it didn't work properly. I'm sorry for the delay.

Congratulations again on completing you MechMate!

Last work I've done was a landscape for archittectural modeling.Time of milling was 5 hours. I was afraid what to do if I must stop the machine in the midle of the work, How to find a zero position and countinue.I have put two cuper plates on the angle of base table to find a zero position (mach blue screens).
Whatever hapens I can find the same zero position in this way and continue
using "run from here" mach3- option.If I start to work in the center of the base table I can Write the DRO coordinates x and y to be shure that my zero point is the same.Am I wrong?
Some photos
Attachment 12008
[ATTACH]Attachment 12010[/ATTACH]

Hi Vanja, that is a much needed addaption the Mechmate, your understanding is correct about the offset and the zero finding, i have also added the x/y probing to my mechmate, on long carving time projects i also put a V bit into the collect and mark the X and Y positions on the outer parimeter of the material, i guess I will do that untill i am more knowledgeable about what i am doing.