|
|
#31
Sun 06 January 2013, 20:51
|
|||
|
|||
|
People have done plasma cutters, a laser cutter should not be that different.
I have not seen any documented builds that have used one though. Some machines at CNCzone have had lower power lasers on them for light cutting and engraving. 
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Plasma Cutting....anyone doing this?? | Mitch_1 | 50. Toolheads | 1 | Mon 09 November 2009 16:26 |
| Swivel Head for z axis | rocky2889 | 50. Toolheads | 2 | Sun 01 March 2009 20:48 |
| Converting Base Table For Plasma Cutting | rkrecak | 10. Base Table | 3 | Tue 18 December 2007 10:55 |
| Tilt & Swivel Head for z axis | eloid | 50. Toolheads | 5 | Sun 04 March 2007 06:59 |
