|
|
#1
Wed 06 July 2011, 18:23
|
|||
|
|||
|
Steam Engine Building
Does anyone out there have any experience in building a steam engine from a casting kit? I have found several sources (http://www.pearlengine.com/index.htm and http://www.reliablesteam.com/RSE/RSEengines.html) but hesitate to start a project without some support (Mechmate for steam?)
 Your thoughts. Thanks Joe #53 
|
|
#2
Wed 06 July 2011, 19:02
|
|||
|
|||
|
|
|
#3
Wed 06 July 2011, 19:19
|
|||
|
|||
|
Mike:
Thanks, unfortunately I am currently in Beijing and all YouTube is blocked by the government here. I will check this out when I get home. Joe
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Building a plasma table - Utah, USA | MikeGyver | Construction started, but not cutting yet | 4 | Fri 28 January 2011 05:01 |
| i am getting close to building me one - missouri | gwlewis | Introduce yourself and start planning | 1 | Mon 11 May 2009 23:16 |
| Runs out of steam? Machine freezes during cutting - controlling PC's performance | liaoh75 | Troubleshooting | 11 | Thu 23 October 2008 22:34 |
| Anyone in the Indianapolis area building one? | Medemt | Archives | 0 | Fri 11 July 2008 11:44 |
| MOI : Free nurbs modeler with Rhino engine. | grandpi | Graphics & CAD | 1 | Fri 14 December 2007 13:07 |
