|
|
#1
Sat 22 January 2011, 01:37
|
|||
|
|||
|
Howdy from Manitoba, Canada
I was directed to mechmate by a fellow MB'er and I see there is lots to read up on. Looking forward to all the learning and pictures.
I am fairly new to cnc in mind and even less experience in body but hoping to change that in the near future. Looking at a 4ft x 4ft or 4ftx8ft cut area with a vac table to cut polystyrene sheet. If anyone cuts HIPS (high impact poly styrene) sheet I would love to visit about those aspects. Kent aka MPMW 
|
|
#2
Sat 22 January 2011, 12:18
|
|||
|
|||
|
Welcome MPMW!
lot's of information here, and don't hesitate to ask! If in the future you are planning to cut 8x4, then I would suggest to make that right away, given you have the space. Ries
|
|
#3
Sat 22 January 2011, 15:16
|
|||
|
|||
|
welcome kent!
|
|
#4
Sun 23 January 2011, 12:39
|
|||
|
|||
|
Welcome Kent!
|
|
#5
Sun 23 January 2011, 14:13
|
|||
|
|||
|
Welcome to the team !!!
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| One year later - a report back #29 - Manitoba Canada | astrolavista | MechMates already cutting | 33 | Fri 13 August 2010 15:58 |
| Motiontek, Canada | djharris | General - MM Build | 2 | Thu 11 February 2010 07:40 |
| Considering s trip to Canada for your holidays ? | Robert M | Miscellaneous / General / Whatever / Catchall | 6 | Wed 23 December 2009 10:19 |
| hi!! from shawinigan,Québec,Canada | zenair10 | Introduce yourself and start planning | 6 | Sun 20 December 2009 06:50 |
| Hello from Canada - Winnipeg, Manitoba | edwardo | Introduce yourself and start planning | 18 | Mon 13 April 2009 09:00 |
