I have a cnc shark which uses a NC pod.

I want to use it with mach3 and also basic control panel.

I run two different classes that use different software.

I see there is a usb driver for mach 3 called ncpod usb driver

I see there is a firmware installer (v2031) for mach 3.

Is it a matter of changing drivers to suit mach3 and basic control panel?

Or are there two firmware installers that are mutually exclusive?

Can I swap between firmware versions easily? If so how?

If I have two different pcs one with mach3 and drivers and the other with basic control ad drivers will that work?

Thanks Peter.

Peter

I have some interest in your question,

However this being a site for Mechmate builders I think it would be more appropriate to ask over at the Mach3 site,

http://www.machsupport.com/forum/index.php

I will watch for your post there. :)

Greg