MechMate CNC Router Forum - Small Footprint MechMate Mounting Spindle and Support Board!

Page 2 of 2

Show 40 post(s) from this thread on one page

MechMate CNC Router Forum (http://www.mechmate.com/forums/index.php)

- Construction started, but not cutting yet (http://www.mechmate.com/forums/forumdisplay.php?f=77)

- - Small Footprint MechMate Mounting Spindle and Support Board! - Geelong Australia (http://www.mechmate.com/forums/showthread.php?t=2585)

KenC	Mon 25 April 2011 23:19

I run my present 2.2kW spindle in the region of 8~10A most of the time @16000~20000rpm depending on the cutter sharpness...
Been dreaming about uprating the spindle when money is available...
BUT 3kW or 4kW spindle... Just can not make up my mind...

All times are GMT -6. The time now is 10:39.

Page 2 of 2

Show 40 post(s) from this thread on one page