Drawing 10 10 300
 

I hope I have not screwed up too badly. I am able to get my rails parallel to each other however my "M" dimension is out at one corner by 3 to 4 mm. I believe that I messed up on one of the lower cross braces length.
Is this a serious issue?

Thanks for any input

Greg

If you are using 1/2" wide rack, a variation of 3-4mm in M should be no problem. Do you have a minimum M of more than 1/2" all over?

Gerald;

Yes I do have enough room all around for the rack. I was hoping that that would be the response. Thank-you very much.

Greg