#1
|
|||
|
|||
Starting Up in Atlanta ga.
Hello all
Been reading for a while and lurking ,finally decide to flip switch and start planing. Purchased the plans this week and will be putting together an electrical /electronics shopping list soon after more research. Shooting for a 60"x 120" table as part of my fabrication with the machine will be custom acrylic aquariums with the majority being stairs and cabinetry. I havw average welding skills and mechanical abilities and 25 years of custom stair, cabinetry and interior trim experience. I am excited about the build! Thanks all David Kimbrell |
#2
|
|||
|
|||
Welcome
Welcome aboard.
Enjoy the process as I am just starting as well. Mick |
#3
|
|||
|
|||
Welcome Dave!
|
#4
|
|||
|
|||
Welcome
Check out this thread. I have good starter kits for the electrics. http://www.mechmate.com/forums/showt...=Electric+Kits |
#5
|
|||
|
|||
Thanks Mike couple of pms sent
|
#6
|
|||
|
|||
Welcome Dave this is a great project.
|
#7
|
|||
|
|||
WARNING to all the new builders of this fantastic machine :
Just watch out...this thing is not a PROJECT...it's a lifestyle...Really addictive. I think I will be booked into a rehab program soon.. |
#8
|
|||
|
|||
Agree with you Kobus it's a lifestyle indeed!!
|
#9
|
|||
|
|||
I can see how it gets a little addictive. I was quizzing a friend about his shopbot and before it was over he was asking me about the mechmate!
|
#10
|
|||
|
|||
And a lively hood too.
|
#11
|
|||
|
|||
Its like getting a tattoo its for life
|
#12
|
|||
|
|||
well not much to report but I did get my pc today!
Still trying to decide on the motor/ driver and reduction choices |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Starting up in AZ | Mojo | Construction started, but not cutting yet | 43 | Wed 15 January 2014 06:46 |
Another Mechmate in Progress - Atlanta GA | Jay Waters | Construction started, but not cutting yet | 33 | Fri 22 April 2011 07:35 |
Starting to make progress | peter__jackson | Construction started, but not cutting yet | 7 | Wed 27 October 2010 10:28 |
New Guy Starting Build | oscaryrc | Introduce yourself and start planning | 1 | Sun 08 August 2010 17:52 |
Starting point for motors. | tangocharlie123 | Motors & their mountings | 5 | Mon 19 July 2010 22:53 |