#31
|
|||
|
|||
Builder's Log Update
Greetings Vanja,
Congratulations on your new MechMate and on earning Serial #84. Here is the Updated Builder's Log. Please review your entry and let me know any changes you want to make. |
#32
|
|||
|
|||
Thanks all !!!!
Sorry for the worst built time I've done. |
#33
|
|||
|
|||
Center finding works like Danilo said. I have changed feed rate ( 100 insteed of 4)
|
#34
|
|||
|
|||
Congratulations Vanja!
|
#35
|
|||
|
|||
Updated Builder's Log
Vanja,
The Update to the Builder's Log that you requested is complete, here. Thank you for providing the update. I made the change at the airport while on vacation and it didn't work properly. I'm sorry for the delay. Congratulations again on completing you MechMate! |
#36
|
|||
|
|||
Last work I've done was a landscape for archittectural modeling.Time of milling was 5 hours. I was afraid what to do if I must stop the machine in the midle of the work, How to find a zero position and countinue.I have put two cuper plates on the angle of base table to find a zero position (mach blue screens).
Whatever hapens I can find the same zero position in this way and continue using "run from here" mach3- option.If I start to work in the center of the base table I can Write the DRO coordinates x and y to be shure that my zero point is the same.Am I wrong? Some photos angolo.jpg [ATTACH]angolo flesh.jpg[/ATTACH] |
#37
|
|||
|
|||
Hi Vanja, that is a much needed addaption the Mechmate, your understanding is correct about the offset and the zero finding, i have also added the x/y probing to my mechmate, on long carving time projects i also put a V bit into the collect and mark the X and Y positions on the outer parimeter of the material, i guess I will do that untill i am more knowledgeable about what i am doing.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Starting out to actually cut something - cutters, speeds, depths, directions, etc. | Richards | General - MM Operating | 22 | Tue 09 July 2013 03:02 |
Speeds, Feeds, Materials and Bits | smreish | Cutting various materials - bit selection, feeds, speeds | 65 | Sun 11 March 2012 08:01 |
hello from Italy (Naples) | federicodimeo | Introduce yourself and start planning | 1 | Mon 25 October 2010 11:24 |
Hello to all from Italy | Biribago | Introduce yourself and start planning | 2 | Tue 06 April 2010 21:58 |
Ciao from Italy ! | silverdog | Introduce yourself and start planning | 15 | Thu 04 June 2009 12:37 |