#1
|
|||
|
|||
Noob from Alabaster, AL
Just started reading up on all the information here.
As a computer programmer with some decent shop skills I can say this is still a bit overwhelming Anyone near Birmingham, that actually has one running? Would love to see one in action before I decided to try and build one. Thanks, Dustin |
#2
|
|||
|
|||
Not near AL, but welcome aboard. Not the same thing, but you can always search MechMate on Youtube, and see some good examples.
Best of luck. Mark |
#3
|
|||
|
|||
Yeah I will do that, I always forget to check youtube out of habit because they have it blocked at work. I will take a look there and keep reading.
|
#4
|
|||
|
|||
Welcome aboard !!!
|
#5
|
|||
|
|||
We have a few machines in build phases and at least one running in Alabama at the moment.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Noob from Ontario, Canada | pixelsnprint | Introduce yourself and start planning | 28 | Mon 07 April 2014 07:40 |
Noob here looking at first build | rjaze | Introduce yourself and start planning | 4 | Mon 26 December 2011 21:57 |
Noob build: 5 x 10 with roller bearing R&P | toolfool | Introduce yourself and start planning | 1 | Sat 25 September 2010 06:10 |