|
Register | Options | Profile | Last 1 | 3 | 7 Days | Search | Today's Posts | Mark Forums Read |
|
Thread Tools |
#1
|
|||
|
|||
Chinese Spindle Issue
This is just a heads up to anyone else who comes across this problem. My 3kw air cooled Chinese spindle has run reliably for 3 years until a couple of days ago when in the middle of a rush job it stopped spinning. It was making noise and varying the frequency would alter the noise but the spindle was only making feeble efforts to turn. I was all set to order a new spindle but delivery was going to be about 10 days for a reasonably priced one. I had checked all my wiring for continuity but as a last resort I dismantled the connector on the spindle. It turned out one of the wires had worked loose as they only use screw terminals.
|
#2
|
|||
|
|||
Just to add my comment. I changed the connector and found that grounding pin is not connected at all - 3kw air cooled spindle.
Milosh |
Register | Options | Profile | Last 1 | 3 | 7 Days | Search | Today's Posts | Mark Forums Read |
Thread Tools | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
#11 Has died a fiery death– Cape Town (S. Africa) | Alan_c | MechMates already cutting | 556 | Tue 10 August 2021 21:54 |
Chinese 4Kw Air Cooled Spindle Dimension | Surfcnc | 50. Toolheads | 6 | Wed 05 February 2014 17:05 |
Update on new Chinese Water cooled Spindle | waynec | 50. Toolheads | 84 | Sun 01 January 2012 20:31 |
Chinese 300Hz spindle | BartDeckers | 50. Toolheads | 6 | Thu 29 December 2011 12:41 |
Chinese 2.2kw Spindle and Mach3 | Radishworks | 50. Toolheads | 14 | Tue 11 January 2011 08:53 |