#1
|
|||
|
|||
Aluminum Minigun Parts
Just a little update...
Machined some thin aluminium. It was not the best to machine but the mechmate did ok. Attachment 6270 Attachment 6271 Attachment 6272 Just some parts for another project. I'm glad I made the machine large enough to make these parts Jayson. |
#2
|
|||
|
|||
Jayson,
That looks like a gatling gun or a ray gun. |
#3
|
|||
|
|||
Nils,
You beat me to it. I was thinking gatlin gun or HHO generator. |
#4
|
|||
|
|||
Nice looking discs! Did you have any problems holding down the small pieces as they were cut free? 1/16" endmill? Nice work.
|
#5
|
|||
|
|||
Interesting
|
#6
|
|||
|
|||
It will be a little minigun when its completed.
Heath, I drilled the holes first then placed a screw in the centre hole to hold it down. I ran around the outside with a 3mm spiral carbide cutter. Jayson. |
#7
|
|||
|
|||
You know when I saw this thread headline I knew who was going to win it.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Aluminum Airplane Control Panel on a Mechmate! | Jayson | The Show Room | 9 | Tue 21 July 2009 03:51 |
ATV licence plate - billet aluminum | Rad Racer | The Show Room | 7 | Sat 20 June 2009 12:07 |
Aluminum vs. Steel | Gerald D | 10. Base Table | 0 | Wed 18 July 2007 00:52 |