#1
|
|||
|
|||
Finding a VFD to suit a 3kW spindle in Denmark
hey all.
Is there someone who can recommend a VFD to suit a 3kW spindel from China, I have abandoned the VFD (Huanyang HY02D223B) That i got with it. it is burnt off ..... :-) There were 2 of the 3 phases going in to the spindel that by accident crossed and then there was smoke coming from the VFD. |
#2
|
|||
|
|||
Nikolaj, you are in Denmark, so it is difficult to recommend a VFD brand to you. Check with your local "shops" to see what they have. Don't tell them it is for a Chinese spindle, because that will make no sense to them. Any VFD that will drive standard 3-phase electrical motor will work. Tell them you want up to 400Hz frequency output. (that is 24 000 rpm) - some VFD's only go 300Hz (18 000 rpm)
|
#3
|
|||
|
|||
thanks a lot Gerald.....
|
#4
|
|||
|
|||
Ah smoked - that's why I like Delta's, a wire short on a delta gets it to fault - without any harm to the drive or motor.
|
#5
|
|||
|
|||
Nikolaj,
Care to share how your chinese VFD burnt? I'm in progress to commission mine, your experience would help me avoid making potential smoke. PS, my project budget had over ran... by a big margin... My better half is suspicious of a mysterious mistress... |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
VFD & motor spindle safety switch | Hans | 60. Wiring & Cable Management | 20 | Tue 24 December 2013 04:47 |
HuanYang VFD, A.K.A. The Cheap Chinese VFD | KenC | 50. Toolheads | 37 | Thu 26 August 2010 13:10 |
Lurching at Reset - interference from spindle VFD | waynec | Troubleshooting | 12 | Thu 05 February 2009 17:00 |
Wiring the VFD and Spindle | waynec | 50. Toolheads | 4 | Thu 18 September 2008 23:09 |
Anyone else finding that they could register, but not post? | Admin | Test Area for this forum | 4 | Sun 20 May 2007 15:57 |