#61
|
|||
|
|||
I also like the drum!
In fact it gives me an idea for remote locating my delta dust collector to the second floor and keeping a small drum beside the table saw and location for the future MM.... IF I move it to the second floor I can enclose it and cut down on some of the noise... Thanks for the Idea |
#62
|
|||
|
|||
Quote:
|
#63
|
|||
|
|||
I was happy about the plates and design. I was unhappy with the local hardware store. I don't have a very good selection of fasteners near me. So I had to do a little brain storming to make things happen. I don't have a machine shop, so I take a different approach than others sometimes.
I used threaded rod couplers, smaller than the space between the plates (because that's all I could get) and a nut, so I could adjust the distance with my calipers to make the plates parrallel. Alot of extra messing around to get the job done. I guess it's no different than building the Mechmate. Everyones has it's unique features to accomplish the same result. Mike |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Belt reduction box build T5 16 to 60 | linus1 | Driving Mechanisms: Rack/pinion, gears, screws, belts & chains | 3 | Sun 25 July 2010 08:26 |
HTS Rapid Tool Changer + 4 Er-16 Tool Holder + 5 Er-16 Collet | bbreaker | The Market Place | 6 | Tue 01 December 2009 00:14 |
Belt-driven spindles | javeria | 50. Toolheads | 6 | Wed 03 December 2008 06:01 |
Replace rack with belt? | LK LLoyd | Archives | 5 | Wed 17 October 2007 13:23 |