MechMate CNC Router Forum

Go Back   MechMate CNC Router Forum > General - MM Build
Register Options Profile Last 1 | 3 | 7 Days Search Today's Posts Mark Forums Read

Reply
 
Thread Tools
  #1  
Old Wed 18 March 2015, 10:28
gallcorn
Just call me: gallcorn
 
Katy Tx
United States of America
Upgrading Router to Mach3

I'm trying to upgrade my old Axyz brand router I purchased in 1996ish to run on Mach3 by adding a new controller. I purchased a breakout board from Campbell designs, but I have no idea how to even start wiring it up! I hope some of the experts on here can guide me! I'm trying to figure out, whether I need to keep using existing connection board, and just replace controller board that talks to Mach3, or I need to scrap it all, and start over. I have included link to pictures showing each existing board, and overall control box. Any help would be greatly appreciated!

https://www.dropbox.com/sh/n0dczl3za...dUROPCqja?dl=0
Reply With Quote
  #2  
Old Wed 18 March 2015, 23:56
KenC
Just call me: Ken
 
Klang
Malaysia
You gotta be a lot more specific when you ask for help.

#ps, I reckon you don't need a Cambel board to convert to Mach3.
Reply With Quote
  #3  
Old Fri 20 March 2015, 09:31
Robert M
Just call me: Robert
 
Lac-Brome, Qc
Canada
Send a message via Yahoo to Robert M Send a message via Skype™ to Robert M
Hate to shoot you this "realty check", but this is a group for MechMate "makers".....not swap from AXYZ or other DIY....In my opinion your most likely welcome aboard, don't get me wrong, but your question should be addressed more on either the CNCzone....or better, the Mach3 support forum.
Best of luck with your project.
Reply With Quote
  #4  
Old Wed 25 March 2015, 09:39
Richards
Just call me: Mike
 
South Jordan, UT
United States of America
Read the posts under the "Electrical and Electronic" section. You should find enough information to get started on your project. The electronics used with Mach 3 will work with a lot of different brands of CNC routers; however, because YOU will be the designer of YOUR router and its electronics, experiment a little until you understand how each part of the control box works.
Reply With Quote
Reply

Register Options Profile Last 1 | 3 | 7 Days Search Today's Posts Mark Forums Read

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Solid State Relay (SSR) for switching Router under control of Mach3 Gerald_D 70. Control Systems 76 Tue 24 February 2015 14:12
Finally completed upgrading #80 - Burlington, NC toad MechMates already cutting 34 Wed 12 October 2011 11:35
Upgrading the spindle already! - Myerstown PA USA SumBum Introduce yourself and start planning 67 Fri 26 March 2010 06:31
Upgrading the vBulletin software that runs this forum Gerald D Archives 54 Mon 20 July 2009 03:26
Router on and off - mach3 Retief 70. Control Systems 9 Fri 03 July 2009 01:42


All times are GMT -6. The time now is 04:04.


Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.