MechMate CNC Router Forum

Go Back   MechMate CNC Router Forum > After Building the Beast - Operating , Troubleshooting and Maintenance > Cutting various materials - bit selection, feeds, speeds
Register Options Profile Last 1 | 3 | 7 Days Search Today's Posts Mark Forums Read

Reply
 
Thread Tools
  #1  
Old Sat 22 September 2012, 06:18
tangocharlie123
Just call me: Pete
 
Gatton Brisbane
Australia
Bit Supplier

Hi Everyone

Doe's anybody have a good supplier that is current for Compression bits also specialty bits preferably on the cheaper side.

anywhere in the world but doesn't charge the earth for postage.

I am using carbidechui for end and ball nose mills.

Pete
Reply With Quote
  #2  
Old Wed 26 September 2012, 09:24
MK_CATANZARO
Just call me: mike #105
 
cincinnati,oh
United States of America
I just found this place. The prices seem pretty fair all around. I've heard good things about southeast tool bits. I just placed my first order with them, set to arrive today.

http://www.carbideprocessors.com/
Reply With Quote
  #3  
Old Wed 26 September 2012, 16:51
Quadro
Just call me: Anthony #77
 
South Australia
Australia
Pete,
I'm also looking for some compession bits, I was after 1/4" or 6mm.
Have you had any luck?
Anthony
Reply With Quote
  #4  
Old Wed 26 September 2012, 17:57
sailfl
Just call me: Nils #12
 
Winter Park, FL
United States of America
I have been using bits from Centurion Tools

http://centuriontools.com

1/4" Mortise Compression 1" Cut Length
SKU: 14CR21.02.5FEM200
$27.80

I cut a lot of cheap China 3/4" ply and even after lots of sheet, they still give a good edge.

If they do not ship out of the country, I would consider an order to one location if you are interested.
Reply With Quote
  #5  
Old Mon 10 December 2012, 19:51
tangocharlie123
Just call me: Pete
 
Gatton Brisbane
Australia
Multi cam

Hi

Sorry for the delay

I found Multi Cam here in Brisbane thier prices are reasonable, postage is overnight freight.
I found on another site that due to the fact that I was after 1.5mmCED you could not get them so the suggestion was run a 1.5 down cut spiral then an upcut through over two passes this has given great results.

Cheers
Pete
Reply With Quote
Reply

Register Options Profile Last 1 | 3 | 7 Days Search Today's Posts Mark Forums Read

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Moore Gear - Rack and Pinion Supplier USA Diane-mooregear The Market Place 0 Wed 13 July 2011 10:31
www.akcesoria.cnc.info.pl - Ogólne dostawca w Polsce (Supplier in Poland) martin77pl The Market Place 4 Sun 22 February 2009 14:15
Aussie Dual Vee & Rack Supplier WillyInAus Rails & Rollers 2 Wed 09 April 2008 02:42


All times are GMT -6. The time now is 19:12.


Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.