#91
|
|||
|
|||
Vishnu,
Very nice frames. |
#92
|
|||
|
|||
Nice Vishnu!
|
#93
|
|||
|
|||
Beautiful work Vishnu.
|
#94
|
|||
|
|||
hi there Vishnu and irfan
good to know you guys are builing the mach i m frm pune wanted to know how much it will cost to make one 10x5 machine bcos you guys have allready done the maths i allways wanted to build a router and a forming machine as well as the from cutting machine which i have the plans for but stoped my self as i did not get the proper curcuit dwgs from the net plus i have no idea of what type of motors to be used servo or stpper want to also know how do i build the controller where r the dwgs of the circuits for the machmate hope u guys will help me imp i want to know the cost please thanks every body for there inputs and thanks a lot mr gerald |
#95
|
|||
|
|||
vishnu irfan want ur mob no i will call thanks once again
|
#96
|
|||
|
|||
Mac if you study the forum - then its very easy to build this machine. all electronics, electrics are discussed in depth on the forum, cost wise it is some where around 4L - but depends on how you go about building one.
RGDS IRfan |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Inspired by Multicam, Y Car Mounted - Randers, Denmark | Kim Mortensen | Miscellaneous / General / Whatever / Catchall | 308 | Mon 08 May 2017 05:37 |
My Mechmate coming up - India | Manjeet Singh | Construction started, but not cutting yet | 13 | Sat 24 May 2014 22:49 |
Using the Oriental Motor Alpha-Step motors on the MechMate frames. | Gerald D | Archives | 1 | Sat 29 September 2007 11:43 |
Hi, new to the gang - Bangalore, India | ANIL | Introduce yourself and start planning | 5 | Sat 09 June 2007 09:45 |