![]() |
#1
|
|||
|
|||
Nema 34 Motor covers for the back
http://www.cnc4pc.com/Store/osc/prod...roducts_id=855
FINALLY! For those machines that have open back motors and need a place to protect the wiring....CNC4PC has a plastic back made just for the NEMA 34 motors. Comes with mounting screws and wiring connection too. 20$ each A bit pricey - but great solution (and they look nice) |
#2
|
|||
|
|||
wow... too expensive & its plastic, no good for heat dissipation. glue a cheap heat sink or Al foil would had do the job.
|
#3
|
|||
|
|||
For normal use a stepper does not need extra cooling, and the plastic would do just fine. Steppers are perfectly ok with <80 degrees heat to work in (unlike humans ;-)). For hot countries a massive sheet to the front of the stepper would do way better in disepating heat and is also easier to make ( substitute the mounting plate in thicker alu).
A nice cover milled by the MM from stacked alu sheets with heatsink would be nice though KEN ![]() |
#4
|
|||
|
|||
Are you asking a question? I don't understand your previous comment.
|
#5
|
|||
|
|||
Stepper motors on a pump ?
|
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
taking back part of Stepper motor | Fox | Motors & their mountings | 5 | Thu 11 July 2013 02:26 |
Nema 34 set at 6000 velocity stops rotating | viz | 701. Motor Drives | 20 | Sun 21 October 2012 02:49 |
nema 34 | saas | Motors & their mountings | 9 | Wed 29 August 2012 04:55 |
Nema 42 Motor Size Question | 15mgtar | Driving Mechanisms: Rack/pinion, gears, screws, belts & chains | 10 | Fri 09 April 2010 02:39 |
Do the Oriental Motor gearheads fit onto all NEMA stepper motors? | alain26 | Driving Mechanisms: Rack/pinion, gears, screws, belts & chains | 7 | Wed 02 July 2008 08:57 |