|
Register | Options | Profile | Last 1 | 3 | 7 Days | Search | Today's Posts | Mark Forums Read |
|
Thread Tools |
#1
|
|||
|
|||
Stepper Motors
I have come across some stepper motors in my quest to put together my system, I have way more then I need of them so if any one needs some motors please let me know.
490 oz holding 6 amp 1.8 step 3/8 shaft NEMA 34 4 wire units New in box $40.00 each firechief |
#2
|
|||
|
|||
Nema 34 and 3/8" shaft don't sound right - the shaft should be 1/2"
|
#3
|
|||
|
|||
Can you get us a part number?
|
#4
|
|||
|
|||
Stepper Motors
I have called LIN Engineering and he sent me this sheet on the motors
Part # 8618M-11P-02 Let me know if there is something I need to know, all your help is great. Thanks Tim Last edited by firechief; Fri 13 May 2011 at 08:40.. |
#5
|
|||
|
|||
If I found the correct documentation, the 8618L-11P motors have 2.4mH inductance, so they could be used with power supplies up to about 48VDC. The web site shows that they are round motors, so they are an older design than the square motors most of us use; however, I have some old round Superior Electric motors that have worked very well with Geckodrive stepper drivers.
(I have some older PH299 size 34 motors from Oriental Motor that have a 0.375" shaft. All of my square size 34 motors have 1/2" shafts.) Last edited by Richards; Sat 14 May 2011 at 06:34.. |
Register | Options | Profile | Last 1 | 3 | 7 Days | Search | Today's Posts | Mark Forums Read |
Thread Tools | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
stepper motors | andrewuk | Motors & their mountings | 18 | Sun 31 October 2010 09:48 |
Stepper motors for sale | cbboatworks | Archives | 6 | Wed 03 June 2009 18:20 |
Damper for stepper motors | Delamination | Motors & their mountings | 0 | Mon 17 November 2008 11:34 |
stepper motors what brand to use???? | chopper | Motors & their mountings | 19 | Sat 19 July 2008 11:42 |
Stepper motors giving trouble - Motors burnt while serving as ground for elec. fault | Daya | Troubleshooting | 45 | Mon 21 April 2008 01:05 |