#1
|
|||
|
|||
Mechmate with turn mill ?
Hi
I am looking to make MM for turn mill router .Anyone can advice me about how I can do with turn axis ? Thanks |
#2
|
|||
|
|||
Jek - Just read here in the forum. It has been covered. Also look on Youtube for MechMate.
http://turningaround.org/MechMate/Mechmate.htm Also search on 4th axis. |
#3
|
|||
|
|||
Turn mill
Thanks Mike .
I have one MM but need to make new like 4 axis will latch turn mill . But I have no ideal how to make axis can turn same like this link http://youtu.be/Dw7PE73i83o Thanks |
#4
|
|||
|
|||
I like the toolchanger: http://www.youtube.com/v/gwAuL7igCqM
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Profile cutting with cnc mill? | esadaddy | Profiled (laser cut) & bent steel plate | 6 | Sat 27 September 2014 19:23 |
Mill mat | Johannescnc | The Market Place | 3 | Wed 05 May 2010 06:55 |
Milwaukee 5625, how fast do you turn it. | dragonfinder1 | 50. Toolheads | 5 | Tue 16 March 2010 10:33 |
Motors do not turn properly - poor quality wiring used for testing | martin77pl | Troubleshooting | 8 | Tue 31 March 2009 11:36 |
Motors won't turn after the setting up - PMDX-122 jumpers incorrect | lunaj76 | Troubleshooting | 13 | Fri 31 October 2008 04:20 |