#31
|
|||
|
|||
Thanks guys, and thanks for organizing these posts into useful threads.
This forum is such a useful source of info because it's so well organized. It isn't cluttered up with a bunch of irrelevant stuff.... like.... um.... thank you posts. Shutting up now. |
#32
|
|||
|
|||
Quote:
Now I'm having problems with my motors, on the Y axis there is two motors, one of them seems to be working properly but the other one hardly moves and vibrates, went to the troubleshooting page and landed here and you mention that your PMDX-122 came jumpered from the factory ready for use with the G201 and the G202 stepper drivers, not for the G203V stepper driver. JP1 is the jumper to check.)How can I know if mine is at the right setting, now the jumper is set at pin 2-9 and ground. On the X axis when the Z is down I'm having trouble to jog to the right and it is ok to the left, Z up jog is ok in both ways. While I'm at I am also having trouble with my limit switches, can't jog off of them, in Mach3 the Auto limit override is activated. Any help would be appreciated Thank you Last edited by m_leblanc; Sat 14 November 2009 at 18:45.. |
#33
|
|||
|
|||
Problem resolve, the PS wasn't connected properly to the BOB.
I had it connected to pin 5 and 6 while I'm using a regulated 5 volts PS Still wondering about JP1 Thank you all |
#35
|
|||
|
|||
Thank you
|
|
|