![]() |
#1
|
|||
|
|||
Tolerance of laser cutting
Hello everyone !
The laser company ask me what is the tolerance i need for the laser cutting and bending ![]() any help will be appreciated Yosef |
#2
|
|||
|
|||
I have never been asked that question by the 5 different companies that do this work for us. Tell them you want their normal quality and have a look at their samples.
|
#3
|
|||
|
|||
Normally they will do cutting within 1/10 of a mm, and bending will be almost dead on, on angles.
|
#4
|
|||
|
|||
I think You can ask for best tolerance they have. if the same price.
Is possible 0.1mm is normal for laser. |
#5
|
|||
|
|||
The basic design of the MM will allow the laser cutting to be off by more than 0.1mm, maybe even 0.5mm is okay. Therefore, do not ask for any special work at higher prices. Just their normal work, at normal prices should be fine.
|
#6
|
|||
|
|||
Thank you all !
Yosef |
#7
|
|||
|
|||
When I have a job for my lasercuter, I print out a drawing and a place a circle arround the important tollerances in the shop. so he can see what I want. My motorplates were cut inlucing the holes for mounting the bearings. the only thing I had to rework was the place were the laser starts and ended cutting. also the hole was a little tappered. so depending on which site I had to mount the bearing, I had to adjust a little bit. this took only a couple of minuts. I could mound the bearings by pushing them in by hand !!
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Laser Cutting and Bend Service | slobato | Archives | 2 | Mon 04 April 2011 21:07 |
Tolerance in length of y-beams | Red_boards | 20. Gantry | 10 | Wed 26 January 2011 16:57 |
Laser Parts cutting with cnc router | asif3244 | Profiled (laser cut) & bent steel plate | 4 | Wed 01 December 2010 09:36 |
Laser Cutting Parts | lisawaa | The Market Place | 6 | Tue 14 September 2010 12:07 |
Laser cutting in various countries . . . . | vadeem | Archives | 12 | Thu 02 October 2008 07:02 |