|
Register | Options | Profile | Last 1 | 3 | 7 Days | Search | Today's Posts | Mark Forums Read |
|
Thread Tools |
#1
|
|||
|
|||
Mike,
Yes it is the same with Aspire. What I did with one piece was I did a rough cut with 1/4 end mill and 1/4 ball nose. I then did a smooth cut with 1/8 ball nose bit. It took about an hour to cut with the 1/8 ball nose. The first picture is after the 1/4 end mill and the second is after both of the ball nose bits. When I was done, I did not have to sand the material and it was smooth as you could want. |
Register | Options | Profile | Last 1 | 3 | 7 Days | Search | Today's Posts | Mark Forums Read |
Thread Tools | |
|
|