#31
|
|||
|
|||
work in progress
Irfan, i PM you
Today some progress, some grinding tests, but not to much, i finally picked up all parts of reducers first test of grinding, i have to adjust angle of skate, bending is not as good as i expected, but result is not bad and reduction unit : i've to cut & grind rails to test it, sure it will not take too much time |
#32
|
|||
|
|||
Super JB!
Bonne continuation, je bosse aussi sur les rail demain, je penserais bien à toi |
#33
|
|||
|
|||
Can we get a pic of that belt drive on the other side?
Looks Great !!! |
#34
|
|||
|
|||
yes we can...
i've to test them before sharing anything, keep waiting Last edited by jazial; Fri 28 May 2010 at 18:42.. |
#35
|
|||
|
|||
This is great- the first mechmate to run on servo's
btw what make and pricing did the servo's come upto, is this 1:8 reduction? |
#36
|
|||
|
|||
i hope it will run !
this is 1:6 ratio, price of whole mod is 2-3 times higher than steppers |
#37
|
|||
|
|||
I like the look of your setup! It looks mean! I'm looking forward to hearing the results! Great job!
|
#38
|
|||
|
|||
Des nouvelles JB ? Ça coupe ?
|
|
|