#91
|
|||
|
|||
But if it was not fun, you would not be doing it. Right?
|
#92
|
|||
|
|||
How did you go about the lighting? Individually controlled through a controller but is there a letter cutout and the letter inserted in it and the wiring from the back? Great video
Last edited by pblackburn; Fri 08 March 2013 at 17:33.. |
#93
|
|||
|
|||
Hello !
Thank you for sharing your great work ! Could you tell us dimensions of your MechMate ? |
#94
|
|||
|
|||
1500/3200mm working area
|
#95
|
|||
|
|||
Its led strip with sticky tape behind so its just cut to segments placed on the back of the letter and then soldered individual segments inside the letter.
|
#96
|
|||
|
|||
Danilo,
Sorry for the late reply. Thanks so much for the info. It is always nice to see how people do things. |
#97
|
|||
|
|||
Hello !
Could you tell us which breakout boards did you choose ? Are you satisfied with them ? Hardouin |
#98
|
|||
|
|||
PMDX-126 breakout board with the PDMX-134 motherboard. I have two parallel ports to the board to utilized the full features of the board. It gave me the option of using the PMDX-108 and PMDX-109 later if I wished to. The 126 also allows me to add a 5th drive for my 4th axis. The board has not caused me any problems and I am pleased with it's performance.
|
#99
|
|||
|
|||
Very nice job!
|
#100
|
|||
|
|||
After one more visit to my friends in Macedonia, these are the new additions
Massive chinese two spindle router (yaskawa servos , 6hp HSD spindles) Trusty MechMate is still right beside this beast But improved with CS-Labs ethernet CSMIO IP/S 6 axis motion control and redesigned control cabinet |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
DIY drives from pminmo, Cutting Video, #59 - Bitola, Macedonia | gorantec | MechMates already cutting | 61 | Sat 19 October 2013 03:13 |
Can Mechmate be a plasma or gas cutting machine? | bdrotaru | Introduce yourself and start planning | 2 | Mon 04 October 2010 10:17 |
CNC sandline cutting machine | delongcnc | Archives | 7 | Sat 31 October 2009 14:32 |
Is the MM the right machine for Me? (cutting thin boards and thick foam) | 1foamimprovement | General - MM Build | 5 | Wed 18 February 2009 18:24 |
Help me to choose a foam cutting CNC machine! | kotys2 | The Market Place | 3 | Wed 03 September 2008 17:33 |