![]() |
#1
|
|||
|
|||
Z slide cutting errors
Hi,
My MechMate #70 have been heavily modified, transforming it from welded frame, to a bolted one. I am happy with the results but a new problem occurred: each sequential pass on thick board came "a little bigger" (a slight offset). I cutted a 19mm MDF board in three 6.5mm pass, each pass is slightly bigger. All of the sides have the same problem. I suppose there is a little play on the v-bearings ( a thought I had writing this post :-) ) and the force on the mill push the cut on the outside ... Any other ideas ? Sergio Last edited by silverdog; Tue 09 August 2016 at 06:33.. |
#2
|
|||
|
|||
6mm tool? Have you tried cutting in the opposite direction? Or another finishing pass at full depth?
Tool flex, bearing play, mount flex are the ideas that come to mind. |
#3
|
|||
|
|||
Thanks Brad ...
I checked the z axis and there was a little play due to the two upper v-bearing not properly tighted :-) |
#4
|
|||
|
|||
.... but it was not the problem ...
My next check is to change the 6mm mill with a 8mm and see, then che software problems ..... |
#5
|
|||
|
|||
The 8mm mill cut perfectly ! (like never before) you can't see any sign of the multiple pass
So the problem was with the 6mm mill, I think. It wasn't mounted correctly on the chuck. |
#6
|
|||
|
|||
I've seen lots of flex with deep passes in 6mm and smaller tools. It always surprises me that they don't break.
|
#7
|
|||
|
|||
ditto on what Brad said. I have a good deal of flex on the smaller dia bits when cutting. 5/16 (8mm) or larger seem to always yield better results for me.
|
#8
|
|||
|
|||
6mm one flute is my most used bit, I have used many times on much harder material than MDF and never had such an evident problems in 6 years.
The problem I had was that the mill was not properly mounted on the ER20 chuck, the same mill gaved no problem once properly mounted. It was my fault ![]() |
#9
|
|||
|
|||
I cut mainly Extira and I use the 2 flute 1/4 and 5/16. The 5/16 really pulls it out and makes a clean cut. Extira I a heavy dust.
|
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Cutting errors - slop in motors? | Rocky Mountain Teardrops | Troubleshooting | 49 | Fri 29 May 2015 20:01 |
Inconsistant cutting errors. | SOSx | Troubleshooting | 85 | Mon 12 November 2012 03:49 |
Cutting out_of_round circles - loose V-rollers on Z-slide | javeria | Troubleshooting | 22 | Wed 17 June 2009 05:15 |
Stepper motor refuses to turn - Wiring & jumper errors | Gato Richy | Troubleshooting | 31 | Thu 30 April 2009 23:56 |
Z-Slide - width allowance for V-Cap rails on edges of slide plate | YRD | 40. Z-Slide | 5 | Tue 11 November 2008 11:20 |