#1
|
|||
|
|||
Need help with rack dimensions :( - Bitola, Macedonia
sorry if is stupud to ask but im very newbie in this
i have here one suplier and making racks 60 sm long ok its not problem i will connect them but suplier ask me how much tooth did i need on 60 sm long racks so please let me know how much tooth will need ? i was searching on the forum but nothing find and theat why i ask Last edited by gorantec; Fri 10 April 2009 at 04:24.. |
#2
|
|||
|
|||
Ok if you dont understand me i was thinking how much tooth per 60 sm rail
|
#3
|
|||
|
|||
Will your supplier also make the round (circle) gears that will run on the rack?
I ask that question because the round gears must be matched to the rack. We normally use a "Module 1" rack in a metric country. For 60 centimeter there will be 190.986 teeth. |
#4
|
|||
|
|||
yes suplier will also make gears
Thanks for your answer |
#5
|
|||
|
|||
If your gears are direct on the motor shafts (with no gearboxes), then your gear diameter should be 24 millimeter (at the middle of the teeth) and it will have a quantity of 24 teeth.
IF you do have gearboxes on your motor, then you can increase to 36 millimeter average diameter and quantity 36 teeth. |
|
|