MechMate CNC Router Forum

Go Back   MechMate CNC Router Forum > General - MM Build
Register Options Profile Last 1 | 3 | 7 Days Search Today's Posts Mark Forums Read

Reply
 
Thread Tools
  #1  
Old Mon 07 June 2010, 23:30
albertoslayer
Just call me: albertoslayer
 
san blas
Mexico
Pk296a2a-sg7.2

Hi

I want to buy 3 PK296A2A-SG7.2 motors for my mechmate, and I want to know if they can work with a 63 VDC power supply and g203v drives, and the final question is how long is the diameter of the shaft?? because I want to conect them direct to the pinion and my pinions are 1/2 inch of diameter, can I put these pinions in the shaft of these motors???

How it work if I don´t use the 3:1 reduction?

Thank you, And Sorry for my bad English

Alberto
Reply With Quote
  #2  
Old Tue 08 June 2010, 00:19
Richards
Just call me: Mike
 
South Jordan, UT
United States of America
Alberto,

The PK296A2A-SG7.2 motor has 1.5mH of inductance if you wire it half-coil. So MAXIMUM voltage is about 40 VDC if the motor is wired half-coil. If you wire the motor bipolar-series, the inductance is 6mH, so you could use a 78VDC power supply; however, wiring a motor bipolar-series greatly reduces the motor's top speed.

I use a 35VDC power supply with my PK296A2A-SGxx motors and I wire the motors half-coil.

The shaft is 1.14-inches long (29mm). and it is 0.5-inches in diameter (12.7mm). Many people use a 1.25-inch or 1.5-inch pitch diameter spur gear with that motor.

You would not use a 3:1 belt drive with that motor. The motor already has a 7.2:1 gear box attached.
Reply With Quote
Reply

Register Options Profile Last 1 | 3 | 7 Days Search Today's Posts Mark Forums Read

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Backlash in the gearhead of the Oriental Motor PK296A2A-SG7.2 Gerald D Driving Mechanisms: Rack/pinion, gears, screws, belts & chains 37 Sun 22 September 2013 07:58
Aussie Builders - Anyone Wanting to Sell Their PK296A2A-SG7.2 rotorzoomer The Market Place 3 Sat 10 April 2010 22:01
Resistors for G504 and wiring for PK296A2A-SG7.2 motors (unipolar) jehayes 701. Motor Drives 7 Sun 15 November 2009 18:16
motor problems vexta pk296a2a-sg7.2 chopper Archives 1 Tue 28 April 2009 23:37
Are these the same: Pk296ae-sg7.2 (metric) = Pk296a2a-sg7.2 (inch)? gixi Motors & their mountings 15 Wed 26 November 2008 13:39


All times are GMT -6. The time now is 08:15.


Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.