MechMate CNC Router Forum

Go Back   MechMate CNC Router Forum > After Building the Beast - Operating , Troubleshooting and Maintenance > Cutting various materials - bit selection, feeds, speeds
Register Options Profile Last 1 | 3 | 7 Days Search Today's Posts Mark Forums Read

Reply
 
Thread Tools
  #1  
Old Wed 11 November 2009, 02:10
isladelobos
Just call me: Ros
 
Canary Islands
Spain
Send a message via MSN to isladelobos Send a message via Yahoo to isladelobos
countersunk bit selection

Im searching the countersunk bits for countersink the holes, but need recomendation for this tool.

Im searching a good set for my workshop.

And the best drill material recomendation.
Reply With Quote
  #2  
Old Sat 14 November 2009, 07:15
Gerald D
Just call me: Gerald (retired)
 
Cape Town
South Africa
Ros, can you give me some web pages where you normally select your tools? Then I can make suggestions from those pages. (otherwise we will have a lot of difficulty with the names in different languages)
Reply With Quote
Reply

Register Options Profile Last 1 | 3 | 7 Days Search Today's Posts Mark Forums Read

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Transformer Selection KenC 702. Power Supplies 2 Tue 21 July 2009 06:14
servo selection ashish_hal Archives 3 Wed 24 September 2008 07:13
Proper bit, speed an IPM for fir,pine and western red cedar Art Cutting various materials - bit selection, feeds, speeds 6 Mon 22 September 2008 15:25
Spindle selection skypoke 50. Toolheads 11 Fri 23 May 2008 04:20
1010123 Support Board - material selection (MDF, plywood, other . .) IN-WondeR 10. Base Table 2 Sun 27 May 2007 12:53


All times are GMT -6. The time now is 06:46.


Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.