MechMate CNC Router Forum

Go Back   MechMate CNC Router Forum > Electrical & Electronic > 701. Motor Drives
Register Options Profile Last 1 | 3 | 7 Days Search Today's Posts Mark Forums Read

Thread Tools
Old Thu 21 March 2019, 16:34
Just call me: Luke
United States of America
Spindle Frequency?

I bought and installed a new 1.5hp water-cooled spindle with an inverter to run it. Inverter is esv112n02yxb . Now whenever I switch the spindle on, it triggers my limit switches (in Mach3) and I can only reset it when the spindle is not running. Would adding a line reactor to the inverter help? Spindle and limit switch wiring is all shielded and properly grounded.

I'm virtually at a standstill. Any help?
Reply With Quote
Old Sat 23 March 2019, 04:51
Just call me: Danilo #64
Novi Sad
What breakout board are you using ? is it optoisolated?

If it is isolated I would first try to connect the PC to the mains with small line filter.

also check if everything is properly grounded , if the vfd has internal emc filter try disconnecting it , this was known to make me problems with control techniques vdf
Reply With Quote
Old Sat 23 March 2019, 18:36
Just call me: Al #114
Send a message via Skype™ to lonestaral
I had to put the VFD on a separate earth to
the computer and machine.
Hope this helps.
Reply With Quote

Register Options Profile Last 1 | 3 | 7 Days Search Today's Posts Mark Forums Read

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Water Cooled Spindle Connections - Connecting the Spindle waynec 50. Toolheads 32 Fri 19 June 2009 12:31
Variable Frequency Drives VFD's for spindles Gerald_D 702. Power Supplies 14 Tue 24 March 2009 13:48
Delta Variable Frequency Drive VFDB series - (for the spindle motor) Gerald_D 701. Motor Drives 8 Tue 25 November 2008 10:08

All times are GMT -6. The time now is 15:48.

Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.