#1
|
|||
|
|||
new machine - High Point, USA
hi all. a friend and myself started looking at build a cnc machine, however we have a few questions after reading most of the posts on the forum. would it make the cnc machine sturdier by using linear rails instead of the way the machine is designed now? i am a little (really a lot ) lost trying to decide what size stepper, driver board, and gear rails to use. i would like to use a geared stepper and the right size gear and rail. could someone tell me what geared stepper and pitch of gear/rail to use. we plan on building a 48 X 96 table.
thanks for any help jim |
#2
|
|||
|
|||
Take a look at the forum sections. These questions are covered there.
Selecting Motors Wiring the PK296A2A-SG7.2 motors & power supply voltage selection Hint this is the motor most use! PMDX breakout board Rails and Rollers Rack/Pinion, Gears, Also take a look at others build threads to see how they built their machines. Mechmates already cutting |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Just to say hi.. and point folks in the direction of some FREE software. | yohudi | Archives | 8 | Sat 27 August 2016 16:58 |
Setting up the 0,0 point for a job . . . . | Gerald_D | General - MM Operating | 18 | Tue 07 April 2009 17:56 |
High End Router or Spindle, which way to go? | kanankeban | 50. Toolheads | 14 | Thu 02 April 2009 23:54 |
Machine locks up while travelling at high speed - Tuning the motor speeds and accels | Doug_Ford | Troubleshooting | 3 | Sun 03 February 2008 21:55 |
Need help with high school class | Art | Archives | 4 | Wed 22 August 2007 12:09 |