#31
|
|||
|
|||
Now that's just cool.
Congratulations on your new purchase and helping Joe out! |
#32
|
|||
|
|||
Thanks !! I am excited to get the machine. Joe did an excellent job on the build.
I pulled the feet off to put on some casters until it finds its spot in my shop. When I put a jack on the cross support next to the leg and jacked the machine up, it lifted up the other side at the same time. This table is bolted together and it is still VERY ridged. Heath he bought a Thermwood. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
DIY-rails Which type of angle iron must be purchased? | oddname | Rails & Rollers | 6 | Sat 14 November 2009 07:41 |
Starting out, some parts purchased - Costa Mesa CA | Loren Gameros | Construction started, but not cutting yet | 8 | Thu 12 April 2007 11:58 |