MechMate CNC Router Forum

Go Back   MechMate CNC Router Forum > After Building the Beast - Operating , Troubleshooting and Maintenance > General - MM Operating
Register Options Profile Last 1 | 3 | 7 Days Search Today's Posts Mark Forums Read

Reply
 
Thread Tools
  #1  
Old Sun 05 April 2009, 21:55
Rad Racer
Just call me: Wayne #25
 
Minnesota
United States of America
Clamping fixture

I was struggling with the best method to clamp small parts to the bed of the Mechmate.....this is my solution

The whole assembly can be screwed down to the milling bed, or held in place with c-clamps. The small item you wish to clamp is held in place with the cam locks shown in the picture.

Since it is made entirely from wood (except the bolts) your cutters will be safe if you have a mishap

On the bottom side you can see that holes were machined to the depth of the nut so the assembly sits flush on your cutting table. The holes are slightly smaller than the nut so they hold themselves in place....once pressed into the wood.
Attached Images
File Type: jpg Clamp fixture 1.JPG (88.3 KB, 262 views)
File Type: jpg Clamp fixture.JPG (92.8 KB, 263 views)
File Type: jpg Clamp fixture 2.JPG (89.7 KB, 262 views)
Reply With Quote
Reply

Register Options Profile Last 1 | 3 | 7 Days Search Today's Posts Mark Forums Read

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -6. The time now is 05:08.


Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.