#1
|
|||
|
|||
PROBLEM with 10 10 332 S
hello
I have a problem with the plans 10 10 332 S I read on the C of 180mm 2 cut of 3083mm but how is this possible with an angle of 60° it is too short it s ok with 2 angles of 45° there is necessarily something I don't understand? thank you for enlightening if you have been confronted with this reflection Last edited by woodibe; Sun 27 February 2022 at 15:12.. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problem with slaved axis | MK_CATANZARO | Troubleshooting | 4 | Fri 02 January 2015 10:58 |
Settings problem??? | ilmataat | 70. Control Systems | 11 | Mon 15 July 2013 22:05 |
Push Button Problem | hflwaterski | 70. Control Systems | 10 | Sat 14 January 2012 21:12 |
shutdown problem | paul60 | Troubleshooting | 13 | Wed 30 December 2009 04:42 |
Rack is bowed - is it a problem? | KenC | Driving Mechanisms: Rack/pinion, gears, screws, belts & chains | 5 | Mon 14 December 2009 10:54 |