![]() |
#1
|
|||
|
|||
Heavy duty and cheap motor connectors
To connect motors I bought this cheap (plug & socket only 5 euros) connectors
|
#2
|
|||
|
|||
Ciao Carlo,
Where ? Did you buy the laser parts in italy ? thanks Sergio |
#3
|
|||
|
|||
Sergio, that is the connector between motor car and trailer - many automotive places sell them.
|
#4
|
|||
|
|||
Thanks Gerald,
Yes that conector is easily available, maybe a litle too large for my taste. |
#5
|
|||
|
|||
The modern trailer connectors have become much smaller. But, I still would not use any connector. It is almost never needed to disconnect the cable from the motor - so few times that we can cut the cable and make a new soldered joint if we need to. This is the joint that I trust the most - solder (or crimp).
|
#6
|
|||
|
|||
Yes I use no connectors, the only problem I had with my Mechmate were the gecko connector which were a bit loose, I had to disassemble them and tight the spring. My Mechmate is going to have a new house (a professional location instead of my garage) so a minimum disassemble is needed .... but as usual your advice is the simplest and the better, thanks.
|
#7
|
|||
|
|||
I would use these connectors because I want to share the electronic box with a hot wire CNC foam cutting machine
|
#8
|
|||
|
|||
Yes I'm thinking about adding the 4 axis and one possible simple and economic solution is to use the electronic of one the X axis (as far as I understood I don't need the X axis movement when the 4th axis is in use) with a mach3 dedicated setup and a dedicated motor.
|
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Heavy Duty Leveling Feet SOLD! | JamesJ | Archives | 3 | Tue 08 January 2013 20:29 |
Stepper motor connectors | mrloeng | 70. Control Systems | 0 | Mon 15 March 2010 03:45 |
Soldering DB9 connectors on the motor cables for the Gecko G540 | Gerald D | 60. Wiring & Cable Management | 34 | Sat 23 January 2010 11:19 |
what about connectors like this? | revved_up | 60. Wiring & Cable Management | 7 | Tue 24 February 2009 17:59 |
Heavy spindle | mordalez | 40. Z-Slide | 3 | Sun 11 January 2009 08:49 |