#1
|
|||
|
|||
Need opinion on breakout board
As I was looking for an cheaper and available in Europe Breakout Board (BOB), I found this one
http://www.mechapro.de/catalog/misc-...9icu9gk4fcru82 It really looks ok, but can someone review the manual and see are there some problems and major differences from generally accepted pmdx? it even has the option for din rail mount. here is their manual: http://www.mechapro.de/pdf/Interface...en_2009_05.pdf |
#2
|
|||
|
|||
It looks okay, but the "manual" is a bit hard to understand. If mechapro has good support, then buy it.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Motors loosing steps - Breakout board not suitable | mgandy02 | Troubleshooting | 17 | Mon 02 November 2009 10:01 |
What is the purpose of a spoil board or bleeder board? | j_wizard | 10. Base Table | 1 | Sun 09 August 2009 17:00 |
Need opinion on round bar rails with roller | Claudiu | Rails & Rollers | 3 | Fri 03 July 2009 12:05 |
Power supply for the PMDX-122 Parallel breakout board - 9V AC from main transformer | bradyaero | 702. Power Supplies | 14 | Mon 01 December 2008 15:00 |
Alternative to Mach3 and Breakout Board using USB | dmoore | Miscellaneous / General / Whatever / Catchall | 0 | Thu 22 May 2008 12:59 |