![]() |
#1
|
|||
|
|||
motor tuning g-force in Mach preferred settings
In the motor tuning section of Mach3/4 what is the preferred setting for g-force given the weight of a typical mechmate build?
|
#2
|
|||
|
|||
Mine is set at .081503. The software determined that for me. I could not find a preferred setting, based on weight. I suspect that it would also depend on the motor setup, you have configured. I use a (slow) cutting straight drive setup.
|
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Stepper Motor tuning Help, Please | Jonazizbey | MechMates already cutting | 29 | Sun 21 August 2016 06:07 |
Typical settings for Mach motor tuning | Kobus_Joubert | CNC motion control software | 19 | Sun 15 May 2016 10:04 |
Need help with jog speed in Mach3 motor tuning !!! | rival | Troubleshooting | 45 | Sat 03 September 2011 05:03 |
Mach 3 CV settings | Greg J | General - MM Operating | 2 | Wed 17 November 2010 14:49 |
Gecko / Motor Tuning | sailfl | 701. Motor Drives | 9 | Tue 06 April 2010 12:13 |