#1
|
|||
|
|||
how do I mount a router base to the z plate?
I feel like im asking a dumb question, but how do I mount a router base or a spindle to the z plate, do i need to drill more holes on the plate, or do i use the drilled hole already in the spine of the plate?
|
#2
|
|||
|
|||
Hector,
You need a router bracket that fits the router that you are going to use. The bracket usually has a plate that mounts to the Z plate. Look at the two pictures here: http://www.mechmate.com/forums/showt...p?t=329&page=3 Hope that helps. |
#3
|
|||
|
|||
Remove 4 of the countersunk screws shown on left, drill right through (remove thread from rectangular tube), and screw right through as shown in the center. Or, use the quick-change method with one screw: |
|
|