#1
|
|||
|
|||
Stepper Motor, Driver and Power supply - Kelling
We supply the stepper Motor Drievr and Power supply if you have any request, pls contact us, www.kelinginc.net
We have a kit NEMA 34 906 oz-in Steppper Motors 3 Axis CNC Kit: For Mechmate Route or other application A:3 PCS KL-8060, 80VDC, 6.0A Bipolar Driver, You can Update to G201X or G203 B: 3 PCS NEMA 34-906 oz-in Stepper Motors C:1 PCS C10 Breakout board, E-Stop or Limit Switch can be wired D: KL-6515 Power Supply, 65VDC,15A, 5V, 12VDC http://www.kelinginc.net/CNCNEMA34Package.html |
#2
|
|||
|
|||
Hello John,
The MechMate requires four stepper motors: - two for X (one at each end of gantry) - one for Y-car - one for Z-slide You may wish to adjust your kit to match these requirements. |
#3
|
|||
|
|||
We supply the stepper Motor Drievr and Power supply if you have any request, pls contact us, www.kelinginc.net
We have a kit NEMA 34 906 oz-in Steppper Motors 4 Axis CNC Kit: For Mechmate Route or other application A:4 PCS KL-8060, 80VDC, 6.0A Bipolar Driver, You can Update to G201X or G203 B: 4 PCS NEMA 34-906 oz-in Stepper Motors C:1 PCS C10 Breakout board, E-Stop or Limit Switch can be wired D: KL-6520 Power Supply, 65VDC,20A, power supply http://www.kelinginc.net/CNCNEMA34Package.html |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
TIP142 Stepper motor driver | musicworld1 | 70. Control Systems | 19 | Tue 28 September 2010 21:23 |
The Power Supply needs only to supply 2/3 of the rated motor current | Gerald D | 702. Power Supplies | 0 | Sat 05 December 2009 20:09 |
Would you mind to help me to solve the problem for Keling stepper Motor Driver? | qangel1000 | Motors & their mountings | 6 | Fri 07 August 2009 23:42 |
Keling Stepper, Servo Motor and Driver | Kelinginc | The Market Place | 0 | Wed 16 January 2008 13:55 |