![]() |
#151
|
|||
|
|||
I did a bolt together design based off of Gerald 's design. All crossbearers bolted to main beams, main beams bolted to side legs and cross supports bolted to the side supports. All with sway bracing. If I need to tear apart, I have 1 gantry, 2 sides, 2 cross supports and 9 crossbearers.
|
#152
|
|||
|
|||
I don't think anyones upset, AB.
I wish you luck and success. |
#153
|
|||
|
|||
Yep, nobody's upset. I also have a bolt together machine; beams, legs and X axis bracing welded into two long "side" units, Y axis bracing and the first cross bearer welded together into two short "end" units. The four units bolt together, and then the remaining cross bearers ( with the table surface ) bolt onto the main beams.
|
#154
|
|||
|
|||
Thought I'd chime in at this point. After earlier conversation about the weight I did a quick rough calculation of mine and weigh in at roughly ~2100 lbs + the weight of 10-12 sheets of plywood stored on the shelf below. I originally wanted a bolt together unit but changed my mind for a fixed base and glad I did. It is rock solid (thank to Gerald's design
![]() ![]() ![]() |
#155
|
|||
|
|||
The extra is for trimming flush to the board edge. If they were the same size, most would not be able to match the edges up perfectly in a contact cement application.
|
![]() |
|
|