#1
|
|||
|
|||
A quick job for one of my suppliers (My first export order...)
Attachment 5950 Base is of African Mahogany (I think ) Attachment 5951 Attachment 5952 3D engraved text Attachment 5953 close up of the text - still with direct drive motors |
#2
|
|||
|
|||
I see you also went and visited PTR in Woodstock.Better watch Kobus don`t like it when we do small cutting.What was your feeding speed?
|
#3
|
|||
|
|||
Actually I used a ProTech 30deg V groove I picked up at Hardware Centre CT. Feed speed was 1000mm/min, time to machine about 8 min. I also machined the bevel base with the MechMate. Clamped the block upside down at an angle and ran the head up and down across the block feeding Z down a little bit at a time manually - like one would do on a milling machine, writing the code would have taken me longer .
|
#4
|
|||
|
|||
Hey you guys, what about RETURN on INVESTMENT...you are not suppose to have FUN
Pragtig |
#5
|
|||
|
|||
Beautiful work Alan.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Communion cup holders from hardwood | J.R. Hatcher | The Show Room | 18 | Tue 10 March 2009 11:59 |
Electronics Text Books Online | Bumole | Golden Resources | 1 | Thu 08 May 2008 05:22 |
Engraving text - single line fonts vs. 3D carved | Marc Shlaes | General - MM Operating | 3 | Tue 19 February 2008 07:03 |
Small problems | Admin | Test Area for this forum | 14 | Sat 02 June 2007 23:41 |