MechMate CNC Router Forum

Go Back   MechMate CNC Router Forum > Search Forums
Register Options Profile Last 1 | 3 | 7 Days Search Today's Posts Mark Forums Read

Showing results 1 to 7 of 7
Search took 0.00 seconds.
Search: Posts Made By: mordalez
Forum: 70. Control Systems Tue 24 November 2009, 08:11
Replies: 10
Views: 12,090
Posted By mordalez
Ries, It's not problem with BOB, whole box is...

Ries, It's not problem with BOB, whole box is shutting down.
Gerald, Contactor I'm using is XBS M-IS 24-40:

http://www.mixvill.hu/5/products/393
Forum: 70. Control Systems Tue 17 November 2009, 10:07
Replies: 10
Views: 12,090
Posted By mordalez
Yes I have MM typical control box (except from...

Yes I have MM typical control box (except from door isolator switch). I don't know how low voltage goes, would have to check somehow... I'm not good in electrical stuff at all.

I'll add some more...
Forum: 70. Control Systems Mon 16 November 2009, 06:40
Replies: 10
Views: 12,090
Posted By mordalez
Does charge pump work opposite way (stops Mach 3...

Does charge pump work opposite way (stops Mach 3 coordinates when machine is out of power) ? I have problem with power, when other machines (electrical motor) in workshop is starting I sometimes have...
Forum: Troubleshooting Fri 25 September 2009, 09:35
Replies: 2
Views: 6,478
Posted By mordalez
Thank you Gerald, I have faster reply by...

Thank you Gerald,
I have faster reply by mechmate forum than from gecko support where I sent email day or two earlier. :)
Well I supposed that drive died. I machined no metal yet :) , so no metal...
Forum: Troubleshooting Thu 24 September 2009, 09:41
Replies: 2
Views: 6,478
Posted By mordalez
Gecko 203v red and green light all the time

It started when I tried to switch motor from one gecko to another one (I guess) becouse I had problems with one motor which was caused by poor wiring btw.
I have red and green led light in my gecko...
Forum: 40. Z-Slide Sun 11 January 2009, 08:49
Replies: 3
Views: 10,677
Posted By mordalez
Well yes, it will be heavier to be sure it's...

Well yes, it will be heavier to be sure it's stiff, so steel will be thicker if comes to Y a Z axis construction, but as I mentioned in my earlier post I'm not sure about the construction of Z axis...
Forum: 40. Z-Slide Fri 09 January 2009, 10:31
Replies: 3
Views: 10,677
Posted By mordalez
Heavy spindle

Hello,

It's my first so I would like to say hi to all members :)

I decided I'll start building MechMate, I plan to do V-carving in hard granite so I need spindle with higher power (~6 kW) than...
Showing results 1 to 7 of 7

 
Forum Jump

All times are GMT -6. The time now is 08:42.


Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.