MechMate CNC Router Forum

Go Back   MechMate CNC Router Forum > Search Forums
Register Options Profile Last 1 | 3 | 7 Days Search Today's Posts Mark Forums Read

Showing results 1 to 8 of 8
Search took 0.00 seconds.
Search: Posts Made By: bradm
Forum: Troubleshooting Wed 08 August 2018, 18:46
Replies: 36
Views: 11,732
Posted By bradm
Glad you're solved for now. Onwards and upwards!

Glad you're solved for now. Onwards and upwards!
Forum: Troubleshooting Wed 08 August 2018, 11:12
Replies: 36
Views: 11,732
Posted By bradm
Sorry, I've been away a week. So, "Magic spots"...

Sorry, I've been away a week. So, "Magic spots" in my experience:

- Greater motion resistance due to supply wires, or dust collection. Tends to be nearer the limits, but not exactly on them.
...
Forum: Troubleshooting Thu 26 July 2018, 07:38
Replies: 36
Views: 11,732
Posted By bradm
Um, X80 Y46 is pretty near the limits of your...

Um, X80 Y46 is pretty near the limits of your table, no? So you're pulling the cables farther than at any other time? I'd take a hard look at where the main cable chain transitions to the gantry...
Forum: Troubleshooting Thu 26 July 2018, 07:11
Replies: 36
Views: 11,732
Posted By bradm
I wish we knew what Darin's resolution was. ...

I wish we knew what Darin's resolution was.

First questions that come to mind are:

Is this about a magic location on the table, or is it about the length of time since the start of the job, or...
Forum: Troubleshooting Thu 31 January 2013, 17:37
Replies: 36
Views: 11,732
Posted By bradm
Restating some things from above to make sure the...

Restating some things from above to make sure the assumptions are correct.

1) There is no actual evidence of a power loss in the control box. There is an an observed behavior that is "as if" the...
Forum: Troubleshooting Sun 27 January 2013, 17:23
Replies: 36
Views: 11,732
Posted By bradm
Darin, you must be really frustrated. Since this...

Darin, you must be really frustrated. Since this is a production concern, I think you should go ahead and get another printer cable as well. You can then use a process of elimination.
I'd be...
Forum: Troubleshooting Wed 23 January 2013, 13:33
Replies: 36
Views: 11,732
Posted By bradm
That sounds good and healthy. I'd look at the...

That sounds good and healthy. I'd look at the parallel cable and the power source for the PMDX next.

You might also try disabling your router or spindle, and running an air cut to see if the...
Forum: Troubleshooting Tue 22 January 2013, 16:41
Replies: 36
Views: 11,732
Posted By bradm
Looking back at your build thread...

Looking back at your build thread (http://www.mechmate.com/forums/showthread.php?t=3635) it appears you have a PMDX-126, and that you are using a motherboard based parallel port.

The symptom you...
Showing results 1 to 8 of 8

 
Forum Jump

All times are GMT -6. The time now is 23:38.


Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.