Forum: MechMates already cutting
Fri 11 September 2009, 23:24
|
Replies: 100
Views: 81,573
|
Forum: MechMates already cutting
Fri 11 September 2009, 18:23
|
Replies: 100
Views: 81,573
OMG what?
Well I need to figure this out...
OMG what?
Well I need to figure this out then. Im looking into it right now but if you could post more info Ill take it. Maybe mine smoothed out because it was closer with ten steps at a time? See...
|
Forum: MechMates already cutting
Tue 08 September 2009, 11:32
|
Replies: 100
Views: 81,573
Also make sure you set your steps per rotation....
Also make sure you set your steps per rotation. The 7.2s I believe are 1440 steps per rotation (0.25 step angle) not the 2000 that my Mach3 defaulted to. My motors ran so much better when this was...
|
Forum: Archives
Wed 20 February 2008, 09:50
|
Replies: 11
Views: 15,175
|
Forum: Archives
Tue 19 February 2008, 13:26
|
Replies: 11
Views: 15,175
Mcmaster parts
Im generating an order from Mcmaster and so far know the following:
Cable chain
gas lift
springs for motors
racks and pinions
I havent tracked down the exact cataloge numbers yet but wanted...
|
Forum: Profiled (laser cut) & bent steel plate
Thu 10 January 2008, 19:49
|
Replies: 24
Views: 33,122
|
Forum: Driving Mechanisms: Rack/pinion, gears, screws, belts & chains
Mon 31 December 2007, 14:34
|
Replies: 449
Views: 471,605
|
Forum: Archives
Fri 28 December 2007, 13:28
|
Replies: 151
Views: 94,090
600oz*in X 3.1beltdrive = 1800oz*in.
Then ...
600oz*in X 3.1beltdrive = 1800oz*in.
Then
300oz*in X 7.2 = 2160oz*in ?
I think you said that the max load on the gearbox is 400oz*in, is that true? I couldnt find it anywhere yet. So is that why...
|
Forum: Graphics & CAD
Fri 14 December 2007, 13:07
|
Replies: 1
Views: 7,322
|
Forum: MechMates already cutting
Wed 12 December 2007, 15:07
|
Replies: 489
Views: 407,463
|
Forum: Construction started, but not cutting yet
Mon 10 December 2007, 11:27
|
Replies: 61
Views: 131,437
|
Forum: Graphics & CAD
Fri 23 November 2007, 12:10
|
Replies: 7
Views: 10,536
|
Forum: Construction started, but not cutting yet
Wed 21 November 2007, 12:51
|
Replies: 7
Views: 9,776
|
Forum: MechMates already cutting
Tue 07 August 2007, 13:20
|
Replies: 610
Views: 478,382
|