Forum: 70. Control Systems
Tue 24 November 2009, 08:11
|
Replies: 10
Views: 12,325
|
Forum: 70. Control Systems
Tue 17 November 2009, 10:07
|
Replies: 10
Views: 12,325
Yes I have MM typical control box (except from...
Yes I have MM typical control box (except from door isolator switch). I don't know how low voltage goes, would have to check somehow... I'm not good in electrical stuff at all.
I'll add some more...
|
Forum: 70. Control Systems
Mon 16 November 2009, 06:40
|
Replies: 10
Views: 12,325
|
Forum: Troubleshooting
Fri 25 September 2009, 09:35
|
Replies: 2
Views: 6,770
Thank you Gerald,
I have faster reply by...
Thank you Gerald,
I have faster reply by mechmate forum than from gecko support where I sent email day or two earlier. :)
Well I supposed that drive died. I machined no metal yet :) , so no metal...
|
Forum: Troubleshooting
Thu 24 September 2009, 09:41
|
Replies: 2
Views: 6,770
Gecko 203v red and green light all the time
It started when I tried to switch motor from one gecko to another one (I guess) becouse I had problems with one motor which was caused by poor wiring btw.
I have red and green led light in my gecko...
|
Forum: 40. Z-Slide
Sun 11 January 2009, 08:49
|
Replies: 3
Views: 11,416
Well yes, it will be heavier to be sure it's...
Well yes, it will be heavier to be sure it's stiff, so steel will be thicker if comes to Y a Z axis construction, but as I mentioned in my earlier post I'm not sure about the construction of Z axis...
|
Forum: 40. Z-Slide
Fri 09 January 2009, 10:31
|
Replies: 3
Views: 11,416
Heavy spindle
Hello,
It's my first so I would like to say hi to all members :)
I decided I'll start building MechMate, I plan to do V-carving in hard granite so I need spindle with higher power (~6 kW) than...
|