Forum: 50. Toolheads
Wed 26 November 2008, 05:25
|
Replies: 32
Views: 57,169
|
Forum: 50. Toolheads
Sun 27 January 2008, 08:44
|
Replies: 11
Views: 19,338
|
Forum: 55. Dust Management
Mon 21 January 2008, 05:34
|
Replies: 15
Views: 22,644
|
Forum: 50. Toolheads
Wed 02 January 2008, 16:16
|
Replies: 22
Views: 21,592
|
Forum: MechMates already cutting
Wed 26 December 2007, 16:58
|
Replies: 205
Views: 235,677
|
Forum: 70. Control Systems
Fri 07 December 2007, 16:12
|
Replies: 16
Views: 17,173
|
Forum: Rails & Rollers
Thu 06 December 2007, 17:23
|
Replies: 28
Views: 33,825
Gerald and others, I use vxb bearings on my...
Gerald and others, I use vxb bearings on my router so I think I can answer some of the questions about them. Mine are 20mm shafts and bearings, When I bought mine vxb did not offer the supports for...
|
Forum: Archives
Sun 04 November 2007, 06:14
|
Replies: 31
Views: 32,912
I use vxb bearings on my router for the x & y...
I use vxb bearings on my router for the x & y axis, They work ok for me. BUT I would not use them for your application, The reasons why are because mine do have some play in them, and they are not...
|
Forum: 50. Toolheads
Wed 31 October 2007, 15:55
|
Replies: 38
Views: 41,782
|
Forum: MechMates already cutting
Tue 09 October 2007, 03:50
|
Replies: 176
Views: 122,870
Hugo terminal #10 must be connected to a ground...
Hugo terminal #10 must be connected to a ground of your breakout board, this was something I ran into when I hooked mine up, do not connect it to your power supply ground. This is how the vampires...
|
Forum: Troubleshooting
Tue 09 October 2007, 03:50
|
Replies: 19
Views: 18,258
Hugo terminal #10 must be connected to a ground...
Hugo terminal #10 must be connected to a ground of your breakout board, this was something I ran into when I hooked mine up, do not connect it to your power supply ground. This is how the vampires...
|
Forum: Archives
Fri 05 October 2007, 16:11
|
Replies: 82
Views: 48,829
Here is a link for you: ...
Here is a link for you:
http://cgi.ebay.com/Stepper-Servo-Motor-Shielded-Wire-Cable-20awg-4cond-CNC_W0QQitemZ180165658579QQihZ008QQcategoryZ67000QQssPageNameZWDVWQQrdZ1QQcmdZViewItem
|
Forum: MechMates already cutting
Fri 28 September 2007, 17:27
|
Replies: 176
Views: 122,870
|
Forum: MechMates already cutting
Thu 27 September 2007, 15:27
|
Replies: 176
Views: 122,870
|