Forum: The Show Room
Wed 24 September 2014, 03:12
|
|
Replies: 17
Views: 23,455
|
|
Forum: The Show Room
Tue 13 May 2014, 07:59
|
|
Replies: 17
Views: 23,455
|
|
Forum: The Show Room
Mon 12 May 2014, 14:39
|
|
Replies: 17
Views: 23,455
|
|
Forum: The Show Room
Mon 12 May 2014, 10:05
|
|
Replies: 17
Views: 23,455
Hi Darren
If you have been looking at them...
Hi Darren
If you have been looking at them then you will know the completeness of the Vacuum Former plans, (including details for building it in three sizes), right down to a bill of materials and...
|
|
Forum: The Show Room
Wed 07 May 2014, 08:42
|
|
Replies: 17
Views: 23,455
Vacuum Former Plans
We built the Vacuum Former with plans from:
http://build-stuff.com/1002plans_proto-form.htm
It was the best $65 I ever spent. Not only were the plans compete and accurate ut there were details...
|
|
Forum: The Show Room
Tue 06 May 2014, 11:14
|
|
Replies: 17
Views: 23,455
3D Subtractive Printing
The news is filled with 3D additive printers making awesome 4 cubic inch projects. Well we MechMate folks have been doing 3D subtractive printing for years, we just didn't know enough to call it...
|
|
Forum: Miscellaneous / General / Whatever / Catchall
Fri 13 January 2012, 09:43
|
|
Replies: 13
Views: 12,942
Photos Available
Hi Mike
Last night I posted the existence of our MechMate on your site.
To see over 60 pictures of its construction go to:
http://www.routerford.com/photos/index.html
Be sure to click on...
|
|
Forum: MechMates already cutting
Thu 12 January 2012, 23:38
|
|
Replies: 15
Views: 27,011
|
|
Forum: MechMates already cutting
Thu 12 January 2012, 22:41
|
|
Replies: 15
Views: 27,011
|
|
Forum: MechMates already cutting
Thu 12 January 2012, 20:07
|
|
Replies: 15
Views: 27,011
Why the lighter table? Shaking on sharp turns???
Hi
Thanks for your feedback.
We did not start out to make it lighter. We wanted to make it transportable so we did a structural analysis and decided that a box beam vs open C channel structure...
|
|
Forum: MechMates already cutting
Thu 12 January 2012, 18:54
|
|
Replies: 15
Views: 27,011
Built and Cutting in Ottawa Canada
After much procrastination, I have finally gotten around to posting on this most useful forum. I am a little late. The machine is already cutting. I hope the associated web site and photos are worth...
|
|
Forum: MechMates already cutting
Thu 12 January 2012, 18:36
|
|
Replies: 15
Views: 27,011
Introduction, Built, Cutting #90 - Ottawa Canada
Hi All
After much procrastination about posting, as we were focussed on getting it done, I have finally gotten around to introductions on this most useful forum. I am a little late. The machine is...
|
