MechMate CNC Router Forum - Search Results

		MechMate CNC Router Forum > Search Forums
Search Results

Options

Profile

Last 1 | 3 | 7 Days

Today's Posts

Showing results 1 to 5 of 5
Search took 0.00 seconds. Search: Posts Made By: bradm

Forum: 701. Motor Drives

Fri 12 September 2014, 12:11

Replies: 17

Gecko 203v intermittent fault

Views: 27,047

Posted By bradm

Glad you're up and running, and that PMDX came...

Glad you're up and running, and that PMDX came through for you.

Spare Gecko? You're on the slippery slope to adding another axis :)

Forum: 701. Motor Drives

Mon 08 September 2014, 12:47

Replies: 17

Gecko 203v intermittent fault

Views: 27,047

Posted By bradm

From GeckoDrive...

From GeckoDrive (http://www.geckodrive.com/g203v-troubleshooting)

Forum: 701. Motor Drives

Mon 08 September 2014, 07:59

Replies: 17

Gecko 203v intermittent fault

Views: 27,047

Posted By bradm

Paul, the signal on the step line should toggle...

Paul, the signal on the step line should toggle back and forth between (close to) zero and above 3v ("close to" 5v). When the motor is stopped, it should be at one or the other. When the motor is...

Forum: 701. Motor Drives

Sat 26 July 2014, 11:27

Replies: 17

Gecko 203v intermittent fault

Views: 27,047

Posted By bradm

I'm with Paulo on the importance of using a PCI...

I'm with Paulo on the importance of using a PCI parallel card. It's not just that the voltage is higher at 5V vs 3.5V, it's also that everything is better - the transistors driving the signal are...

Forum: 701. Motor Drives

Fri 25 July 2014, 09:40

Replies: 17

Gecko 203v intermittent fault

Views: 27,047

Posted By bradm

Here are four basic approaches to solving the...

Here are four basic approaches to solving the parallel port problem these days:

1) Buy some old computers. There are large quantities of refurbished corporate desktops...

Showing results 1 to 5 of 5

Forum Jump

All times are GMT -6. The time now is 06:26.