MechMate CNC Router Forum

Go Back   MechMate CNC Router Forum > Search Forums
Register Options Profile Last 1 | 3 | 7 Days Search Today's Posts Mark Forums Read

Showing results 1 to 5 of 5
Search took 0.00 seconds.
Search: Posts Made By: m_leblanc
Forum: General - MM Build Sun 08 September 2013, 19:55
Replies: 8
Views: 13,554
Posted By m_leblanc
The last time I use it, it was working normally,...

The last time I use it, it was working normally, didn't slow down, never smelt anything, holding was has usual, no sign of a coming failure.

The intake is in seal epoxy box with a shop vac filter,...
Forum: General - MM Build Sun 08 September 2013, 17:40
Replies: 8
Views: 13,554
Posted By m_leblanc
, if I close the bleeder valve then it goes to...

, if I close the bleeder valve then it goes to 10"
Forum: General - MM Build Sun 08 September 2013, 17:38
Replies: 8
Views: 13,554
Posted By m_leblanc
When I mention 9", that is with all the gates...

When I mention 9", that is with all the gates sections close and the bleeder valve fully open
Forum: General - MM Build Sun 08 September 2013, 11:31
Replies: 8
Views: 13,554
Posted By m_leblanc
Yes I have a 3/8 bleeder hole to allow fresh air...

Yes I have a 3/8 bleeder hole to allow fresh air to the motors
Forum: General - MM Build Sat 07 September 2013, 18:13
Replies: 8
Views: 13,554
Posted By m_leblanc
Vacuum Pump

Hi to all of you, I made some search on the forum and I didn't find what I'm looking for.
So here it goes, for my vacuum table I'm using 2 (Lighthouse Lh676565-OD-240...
Showing results 1 to 5 of 5

 
Forum Jump

All times are GMT -6. The time now is 14:42.


Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.